Undo / Redo after Images Editing _Vol.08

Question

Why is my Undo / Redo in Designer not working when I leave the Image Editing panel

Pre-Request

1. Minimum release version : Roland DG Connect Designer v2.0
2. Valid Roland DG Connect ID
3. DIMENSE Module is active
4. A Design has been setup

Solution

1. In general when editing an image in with the Image "Editing Tool" Undo and Redo can be performed within this section, once we confirm our image editing = closing the panel.  We commit the on the implemented images editing.   Meaning we save what we have applied and with this the Undo / Redo for Image Editing has been closed.
2. Going into Designer mode adding text you can use the Undo / Redo this will apply on the text in a step by step correction.  On an image it will remove all applied effect and set the image back to its beginning state.  As this is the known status for Designer.
3. Video showing the different Undo / Redo